Smith Systems, Inc. - Item # 281C603, Converter Cable Assemblies
 Search Catalog
      GO   
 All Categories    Converter Cable Assemblies
SEPTEMBER 2005 Version
All Categories > ATEX Certified Passive Sensors > Passive Speed Sensor for Explosive Environments > Converter Cable Assemblies > Item # 281C603  
Request Information

Item # 281C603 Converter Cable Assemblies



    Print Printable Page  
    Email Email This Page  
    Save To Favorites Save To Favorites
  

Image1 Page 6-7

larger image
Converter Cable Assemblies
This active cable assembly converts passive speed sensors to active digital output. Cable assembly has a built-in amplifier that allows the user to upgrade his passive sensor sine or analog waveform output to a digital square wave output. Benefits include better detection of lower speeds, greater sensor to actuator air gaps and higher noise immunity. Connector mates with industry standard size 10 5015 series 2 pin connectors found on most catalog speed sensors. Cable operates from 6 to 28 VDC at 10mA maximum current and has an output impedance of 200 ohms. This cable will convert an input signals as low as 65 mV pk-pk. into a square wave output signal approximately equal in amplitude to the input supply voltage.


 Specifications  

Wiring Key

Red=Supply (+) Black=Common (-) White=Signal

Length

15 ft

Pins

2

M/F

F

Connector

MS3106-10 SL-4S

Request Information